Skip to product information
Lumishore ECLIPSE SL100 2.5m White Marine LED Strip Light, IP68, 12V (60-0488-2500, 010-04481-00)

Lumishore ECLIPSE SL100 2.5m White Marine LED Strip Light, IP68, 12V (60-0488-2500, 010-04481-00)

UPC: 847772003385
Out of stock
$79.99
Full Factory Lumishore Warranty

Factory Authorized Retailer

25 Years of Excellence in Customer Service

The Lumishore SL100 ECLIPSE White Marine LED Strip Light provides 2.5 meters of flexible accent lighting for cockpit edges, interior architectural features, and protected exterior installations. Its sealed, low-profile construction allows the strip to follow suitable contours, while the ECLIPSE lighting platform supports additional control options for compatible systems.

Key Features & Benefits

  • Marine Accent Lighting: Provides white illumination in a 2.5m strip for indirect and decorative illumination.
  • Single-Color Output: Dedicated white LEDs provide a consistent lighting color without a separate color-mixing interface.
  • Sealed, UV-Resistant Construction: Fully encapsulated lighting resists water and salt exposure, with an IP68 enclosure rating; it is not intended for permanent underwater placement.
  • Cut-and-Seal Design: Cut at the manufacturer-specified 50mm intervals and seal the new end to suit the installation.
  • Convenient Attachment: Adhesive-backed strip can also be secured using suitable fixing clips.
  • Optional Integrated Control: The compatible ECLIPSE Command Center adds dimming, zone control, and additional effects.

Technical Specifications

  • Length: 2.5m (8.2 ft)
  • Lighting family: ECLIPSE SL100
  • LED color: White
  • Power supply: 12V DC only (10–15V DC)
  • Maximum current consumption: 0.5A per meter at 12V (manufacturer data sheet)
  • Power consumption: 6W per meter at 12V
  • Calculated maximum for 2.5m length: 15W / 1.25A at 12V
  • Ingress protection: IP68
  • Cross-section: 10.8 x 4.0mm (0.425 x 0.157 in.)
  • End cap: 12.0 x 5.2mm (0.472 x 0.204 in.)
  • Cut increments: 50mm
  • Minimum vertical bend radius: 50mm; do not bend horizontally or twist
  • Construction: fully encapsulated and potted; UV-resistant; salt-spray tested
  • Installation: adhesive backing and fixing clips

Compatibility

  • Compatible with 12V DC ECLIPSE lighting installations and ECLIPSE Command Center control.
  • Do not connect directly to 24V DC or AC supplies.
  • Can use a suitable basic on/off switch; full zone control and dimming require a compatible ECLIPSE Command Center.

Installation & Setup

  • Disconnect electrical power before fitting or cutting. Cut only at the marked 50mm intervals, and seal the cut end before applying power.
  • Install on clean, supported surfaces; observe the minimum 50mm vertical bend radius without twisting or horizontal bending.
  • Plan current draw and properly fused power distribution for the full connected length.
  • Avoid continuous submersion and prolonged strong direct sunlight.

Warranty

3-Year Manufacturer Warranty

Related products