Skip to product information
Lumishore ECLIPSE SL100 5m Blue/White Marine LED Strip Light, IP68, 12V (60-0489-5000, 010-04485-00)

Lumishore ECLIPSE SL100 5m Blue/White Marine LED Strip Light, IP68, 12V (60-0489-5000, 010-04485-00)

UPC: 753759367183
4 left
$179.99
Full Factory Lumishore Warranty

Factory Authorized Retailer

25 Years of Excellence in Customer Service

The Lumishore SL100 ECLIPSE Blue/White Marine LED Strip Light provides 5 meters of flexible accent lighting for cockpit edges, interior architectural features, and protected exterior installations. Its sealed, low-profile construction allows the strip to follow suitable contours, while the ECLIPSE lighting platform supports additional control options for compatible systems.

Key Features & Benefits

  • Marine Accent Lighting: Provides blue/white illumination in a 5m strip for indirect and decorative illumination.
  • Selectable Two-Color Lighting: Switch between blue and 5000K white illumination with compatible controls; the channels must not be powered simultaneously.
  • Sealed, UV-Resistant Construction: Fully encapsulated lighting resists water and salt exposure, with an IP68 enclosure rating; it is not intended for permanent underwater placement.
  • Cut-and-Seal Design: Cut at the manufacturer-specified 50mm intervals and seal the new end to suit the installation.
  • Convenient Attachment: Adhesive-backed strip can also be secured using suitable fixing clips.
  • Optional Integrated Control: The compatible ECLIPSE Command Center adds dimming, zone control, and additional effects.

Technical Specifications

  • Length: 5m (16.4 ft)
  • Lighting family: ECLIPSE SL100
  • LED color: Blue/White
  • LED density: 60 blue LEDs/m and 60 white LEDs/m
  • White color temperature: 5000K
  • Power supply: 12V DC only (10–15V DC)
  • Maximum current consumption: 0.5A per meter at 12V (manufacturer data sheet)
  • Power consumption: 6W per meter at 12V
  • Calculated maximum for 5m length: 30W / 2.5A at 12V
  • Ingress protection: IP68
  • Cross-section: 10.8 x 4.0mm (0.425 x 0.157 in.)
  • End cap: 12.0 x 5.2mm (0.472 x 0.204 in.)
  • Cut increments: 50mm
  • Minimum vertical bend radius: 50mm; do not bend horizontally or twist
  • Construction: fully encapsulated and potted; UV-resistant; salt-spray tested
  • Installation: adhesive backing and fixing clips

Compatibility

  • Compatible with 12V DC ECLIPSE lighting installations and ECLIPSE Command Center control.
  • Do not connect directly to 24V DC or AC supplies.
  • Can use a suitable basic on/off switch; full zone control and dimming require a compatible ECLIPSE Command Center.
  • The blue and white channels must not be energized simultaneously in a basic switched configuration.

Installation & Setup

  • Disconnect electrical power before fitting or cutting. Cut only at the marked 50mm intervals, and seal the cut end before applying power.
  • Install on clean, supported surfaces; observe the minimum 50mm vertical bend radius without twisting or horizontal bending.
  • Plan current draw and properly fused power distribution for the full connected length.
  • Avoid continuous submersion and prolonged strong direct sunlight.

Warranty

3-Year Manufacturer Warranty

Related products